PROBLEM REASON SOLUTION
Hard starting
No fuel Check and top up
Stale fuel or build-ups in tank
Empty fuel tank and rell with fresh
fuel
Incorrect starting procedure
Perform the starting procedure cor-
rectly
Spark plug disconnected
Check that the spark plug cap ts
well over the plug terminals
The spark plug is wet or the spark plug
electrodes are dirty or placed
inadequately
Check
Air lter clogged Check and clean
Incorrect oil for the season Replace with proper oil
Fuel evaporation in the carburetor
(vapor lock) due to high temperatures
Wait for a few minutes then start
again
Fault in carburation Contact a Licensed Service Center
Hard starting Contact a Licensed Service Center
Inconsistent working
Dirty electrodes or incorrect gap Check
The spark plug cap is inserted
incorrectly
Check that the cap is tted correctly
Air lter clogged Check and clean
Throttle trigger in “CHOKE” position Move the lever to the “FAST” position
Fault in carburation Contact a Licensed Service Center
Fault in ignition Contact a Licensed Service Center
Air lter clogged Check and clean
Loss of power whilst operating
Fault in carburation Contact a Licensed Service Center
Governor out of phase with respect to
the accelerator
Adjust the cable
15. TROUBLESHOOTING
REFILLING AND OPERATION MATERIALS:
Fuel
Engine Oil: From 5° to 35° C
From -25° to 5° C
From -7° to 35° C
Oil Capacity
Spark Plug
Spark Plug Gap
Propane
SAE 30
5W-20 or 5W30
Synthetic 10W-30 or 15W-40
2.0 Liter
F7TRC (NHSP) or equivalent
0.6-0.8mm
To Next Page
Loading...