OPERATOR’S MANUAL
PM100/PM100E Planter Monitor
11001-1426-200612
6 INSTALLATION
IMPORTANT: Be sure harnesses are not pinched, kinked or positioned
against sharp edges and cannot be stepped on.
Figure 3
Monitor And Power Connections
IMPORTANT: The seed monitor is designed to operate on 12 volts DC
only. Always connect red lead to positive (+) battery
terminal and black lead to negative (-) terminal
regardless of whether tractor has a negative or positive
ground system.
CONSOLE MAIN HARNESS
Insert the connectors of the harness into the mating connectors located on
the console bottom. Each connector is different and may only be inserted
into its mate.
Figure 4
Main Harness Connection
Route the main harness to the rear of the tractor. Mount the harness to a
suitable location at the rear of the tractor assuring the connector will reach
the implement connector at the hitch.
+
-
12 Vdc
Red
Black
Power 12V - Red
Ground - Black
Main
Console
Harness
To Next Page
Loading...
