51
ENGLISH
Fig. 10-A
wash them both. Reposition the steel filter by pressing on the plastic part, insert the com-
plete pod holder in its seat and screw the nut back on.
Empty and wash the collection tray on a daily basis (see fig. 5-A).
To clean the steam wand (Frog Vapor), after heating the milk, take a small quantity of hot
water and wipe it externally with a damp cloth.
With each insertion of a new pod, check the correct positioning of the same in its place: an
inadequate insertion could result in damage to the kinematics of the extraction chamber.
When removing the used pod, check that the surface of the pod is not wet.
If it is found to be wet, it is necessary to insert a shim (included as one of the supplied
accessories, see fig. 10-A) at the pod-holder compartment.
Didiesse supplies the coffee machine with 2-3 shims that can be used to resolve this prob-
lem that may arise during use of the machine.
NOTE:
before using the shims, make sure that the pod O-Ring (gasket on the top of the pod-holder
compartment) is intact and not worn.
To Next Page
Loading...
