What to do if no coffee flows out of my DIDIESSE FROG Coffee Maker?
If no coffee is flowing or it's just dripping slowly from your DIDIESSE Coffee Maker, the water level in the bottle might be too low. Refill the water in the bottle. Alternatively, the dispensing spout could be clogged, so try washing it.
What to do if DIDIESSE FROG coffee only flows in drops?
If the coffee from your DIDIESSE Coffee Maker is only flowing in drops, it could be due to insufficient water. Try topping up the water. Alternatively, the dispenser might be clogged, so perform a coffee dispenser washing cycle.
Why is the coffee from my DIDIESSE FROG too cold?
If the coffee from your DIDIESSE Coffee Maker is too cold, it might be because the temperature ready light was on when the switch was pressed. Wait until the desired temperature reached and the light turns off before pressing the switch.
What to do if the loading lever on my DIDIESSE FROG Coffee Maker doesn't reach the dispensing position?
If the loading lever on your DIDIESSE Coffee Maker isn't reaching the dispensing position, it's likely because the pod was inserted incorrectly. Repeat the sequence, ensuring the lever is in the rest position before moving it to the dispensing position.
Why is the coffee from my DIDIESSE FROG too fast and not creamy?
If the coffee from your DIDIESSE Coffee Maker is brewing too fast and isn't creamy, it could be due to a pod that has already been used. Place the lever back in off position and insert a new pod. Alternatively, the coffee ground might be too coarsely. In this case, try using a different blend. Stale or unsuitable coffee could also be the cause, so using a different blend might help.
What to do if the closure lever does not reach the dispensing position in DIDIESSE FROG?
If the closure lever on your DIDIESSE Coffee Maker does not reach the dispensing position, it might be due to incorrect pod insertion. Repeat the operation, ensuring the lever is in the rest position and then moved to the dispensing position.
Why is coffee leaking outside the rim of my DIDIESSE FROG?
If coffee is leaking outside the rim of your DIDIESSE Coffee Maker, ensure that the filter holder is properly fitted into the brew unit. If the issue persists, the boiler gasket might be dirty or worn, so clean or replace it.
Why is the pump on my DIDIESSE FROG Coffee Maker so noisy?
If your DIDIESSE Coffee Maker's pump is very noisy, it might be due to no water in the bottle compartment. Refill the bottle with fresh drinking water or substitute the empty bottle with one full.
Why is my DIDIESSE Coffee Maker not dispensing steam?
If your DIDIESSE Coffee Maker is not dispensing steam, the steam wand is likely clogged. Clean the spout with a needle.
Why is my DIDIESSE FROG not frothing milk?
If your DIDIESSE Coffee Maker isn't frothing milk, the milk might not be suitable. Check the fat content and use fresh, partially skimmed milk. Also, the milk might be too hot; use milk at fridge temperature.
Risks of burns from hot water and steam contact.
Safety precautions for connecting the machine to the power supply.
Guidelines for safe operation by users, including children.
Warning about potential burns from hot surfaces and liquids.
Safety instructions to follow before cleaning the machine.
Guidelines for safe repairs and maintenance procedures.
Specifies the type of water to be used in the machine.
Instructions on using the correct coffee pods.
Safety instructions to follow before installing the machine.
Instructions for connecting the coffee machine to the power supply.
Guide for filling water and starting the coffee machine.
Important note on the type of water to be used in the machine.
General| Type | Espresso Machine |
|---|---|
| Pump Pressure | 15 bar |
| Power | 650W |
| Voltage | 220-240 V |
| Weight | 6.5 kg |
| Capsule Type | ESE Pod |
| Water Tank Capacity | 1.5 liters |
| Material | Plastic |
To Next Page
