52
Frog operating instructions
ENGLISH
Gasket extraction
Gasket removal
Gasket removed
Insertion of a new gasket
If after these possible operations by the user, the machine still shows clear signs of water
leaks, it will be necessary to replace the circumferential gasket present in the lower area of
the extraction chamber.
In this case it is necessary to request the gasket from the Didiesse technical assistance
service and to proceed as follows:
1. rotate the closing lever E from the bottom upwards, in order to release the up/down
mechanism of the extraction chamber;
2. with the aid of a cutter or other equivalent tool, remove the circumferential gasket
from the seat;
3. proceed to insert the new gasket;
4. close the extraction chamber, acting on the closing lever E.
To Next Page
Loading...
