DieHard 28.71687 - Using the Air Compressor; Inflation Procedure; Estimated Inflation Times; Maintenance and Troubleshooting

• 6 •
USING THE AIR COMPRESSOR
WARNING: Read the instructions of the
product being inated before using the
compressor. Avoid overination; do not
exceed the manufacturer’s recommended
pressures. Do not leave the air compressor
unattended during use.
1. Ensure the battery clamps are securely on
the storage holders.
2. Remove the air compressor hose from the
storage compartment in the back of the
Portable Power.
3. Attach the air compressor hose to the
product or accessory to be inated by
ipping down the lever.
4. Place the compressor switch in the ON
position and inate the product.
5. When the product is inated to the proper
air pressure (using the air compressor
gauge) place the compressor switch in the
OFF position and remove the hose.
6. Do not run for more than 10 minutes
maximum at a time. Allow the Portable
Power to cool down for 10 minutes before
using again.
NOTE: To prevent overheating, the
compressor has built-in thermal protection
that will turn the compressor off before it
overheats. If the compressor shuts off, wait
a few minutes and it will automatically
restart when the compressor cools.
NOTE: The air compressor is rated for
150 PSI.
ESTIMATED TIME FOR INFLATING
Vehicle Tires 13"-16" 5-8 minutes
Bike Tires 1-3 minutes
Sports Balls 30 seconds
These times are approximate. Use the air compressor
gauge to ensure the proper pressure has been reached.
Do not overinate.
MAINTENANCE AND CARE
• Clean the clamps and the case each time
you are nished using it.
• Recharge the unit once a month when not
in use.
• Store clamps on their support posts, to
ensure they do not come into contact with
any metallic surface.
• Never completely discharge the internal
battery.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE REASON/SOLUTION
The Portable Power won’t
jump start my car.
Clamps are not making
a good connection to the
battery.
Connections are reversed.
The Portable Power’s battery
is not charged.
The vehicle’s battery is
defective.
The Portable Power is not
turned on.
Check for poor connection to
battery and frame. Make sure
connection points are clean.
Disconnect the Portable Power
and reverse the clamps.
Press the Battery Status
button on the front of the unit.
The LEDs will indicate the
status of charge.
Have the battery checked.
Turn the jump start ON/OFF
switch to the ON position.