• 5 •
GROUNDING AND AC POWER CORD CONNECTIONS4.
RISK OF ELECTRIC SHOCK OR FIRE.
The jump starter charger is for use on a nominal 120-volt circuit. The plug must 4.1
be plugged into an outlet that is properly installed and grounded in accordance
with all local codes and ordinances. The plug pins must t the receptacle
(outlet). Do not use with an ungrounded system.
4.2 Never alter the AC cord or plug provided – if it does not t
the outlet, have a proper grounded outlet installed by a qualied electrician. An
improper connection can result in a risk of an electric shock or electrocution.
NOTE: Pursuant to Canadian Regulations, use of an adapter plug is not
allowed in Canada. Use of an adapter plug in the United States is not
recommended and should not be used.
ASSEMBLY INSTRUCTIONS5.
Remove all cord wraps and uncoil the cables prior to using the jump starter.
FEATURES6.
Jump Start On/Off Switch1.
Digital Display2.
Work Light3.
Two, 12V DC power outlets4.
Rear charger plug (not shown)5.
Clamps and Cables 6.
USB Port7.
Power Switch8.
Wall charger (not shown)9.
1
2
3
4
5
6
7
8
To Next Page
Loading...
