To Next Page

To Previous Page

9. SETTING WATERING RUN TIMES

Note: If you have already set a SimpleSmart

™

ET preset (example: SP02) and then

change the run time, your SimpleSmart

™

program will be turned OFF. You must

reactivate the SimpleSmart

™

programming each time you adjust your run time

(see section 10).

This setting determines the length of time the ECO 1

™

smart controller will allow

the valve to remain open (duration is from 1 minute up to 6 hours). For example,

setting watering run time to 10 minutes on certain days of the week will program

the controller to turn the water on for 10 minutes on each of the days chosen and

at every start time selected.

To set the watering run time :

1. Press the button until the icon appears and OFF or the last run time

setting appears.

2. Press the button, and OFF (or the last run time programmed) appears with

hours blinking.

3. To set a desired watering run time in hours, press or and select the

number of hours.

Questions and Answers:

Need help?

Do you have a question about the DIG ECO1 MVA and is the answer not in the manual?

DIG ECO1 MVA Specifications

General