5. PROGRAMMING
In order to program the ECO 1
™
, you must first let the unit sit out in the light to
charge. Please see page 3 on charging the ECO 1.
This section explains the programming features, and the steps necessary to assign
irrigation schedules. To program the controller use the button to select the
desired programming mode, the button to make the entry flash and the
buttons to change the value.
NOTE: Only a flashing value can be changed.
NOTE: If the last data entered stops blinking, press again to resume
programming and repeat the steps.
6. SETTING TIME AND DATE
The controller can display the time in either a 12 or 24 hour format.
To change the time format, from the home screen after the time has been set:
1. Press and hold the button for three seconds until the display switches
format (AM/PM disappears).
SETTING THE CURRENT TIME AND DATE
To enable the controller to operate properly, the current time and date must
be set.
1. Press the button, until the icon appears along with the time and the day
of the week.
13
To Next Page
Loading...
