30
CAUSE: Flow control handle is turned down
SOLUTION: Open flow control handle on valve or actuator
PROBLEM: Valve/actuator functions in manual mode but not automatically
CAUSE: Controller is set to OFF mode
SOLUTION: Verify that controller does not show OFF in current time mode
CAUSE: AM/PM not set correctly in current time mode
SOLUTION: Check current time, change AM/PM if necessary
CAUSE: AM/PM not set correctly in start time mode
SOLUTION: Check start time(s), change AM/PM if necessary
CAUSE: Watering restriction or rain delay is preventing watering
SOLUTION: Remove watering restrictions or set rain delay to off
CAUSE: Yellow sensor wires have been cut
SOLUTION: Re-connect sensor wires together with waterproof connector
CAUSE: Sensor is installed and is in a state that prevents watering
SOLUTION: Check sensor and wire splices and verify sensor is normally closed
PROBLEM: The display is blank
CAUSE: No buttons have been pushed in the previous 15 minutes
SOLUTION: Push any button
PROBLEM: Valve/actuator fails to close
CAUSE: Valve/actuator is installed backwards
SOLUTION: Check flow arrow and verify arrows points away from water source
CAUSE: Debris is blocking solenoid port
SOLUTION: Shut off water supply, unscrew and remove solenoid, then open
water supply and flush out solenoid port, re-install solenoid
PROBLEM: Rain sensor does not prevent watering
CAUSE: Rain sensor is normally open, malfunctioning, or not wired correctly
SOLUTION: Verify that sensor icon appears on display when pin is pushed
To Next Page
Loading...
Need help?
General
