Digga PDD - Page 20

20 PM-000251 - Operator’s Manual - PDD-PD50 - June 2022
** PRV - Pressure Relief Valve & **ECV - Energy Control Valve
Operating Parameters - HP (KW) Power Ratings
The hydraulic motor of your Planetary drive unit has a maximum power rating. Maximum Pressure & Flow cannot be achieved
at the same time. Ensure you know and understand the maximum ow, pressure and power ratings of your drive unit and
parent machine. Never exceed the maximum ratings listed below. The following charts indicate the maximum capacities of
the drive unit.
9 Before Use
MODEL MAX POWER MAXIMUM FLOW MAXIMUM PRESSURE
MODEL **PRV **ECV Case Drain HP Kw LPM @ BAR BAR @ LPM
PDD Optional Optional Optional 34 25 95 140 240 60
PDX Optional Optional Optional 34 25 95 155 240 60
PDZ3 N/A N/A N/A 34 25 70 200 240 60
PDX2 Optional Optional Optional 34 25 95 155 240 60
PDX3 Optional Optional Optional 34 25 95 155 240 60
PD3 Optional Optional Optional 34 25 115 130 240 60
PD4 Optional Optional Optional 34 25 115 130 240 60
PD5 Optional Optional Optional 34 25 115 130 240 60
PD6 Optional Optional Optional 34 25 115 130 240 60
PD7 Optional Optional Optional 34 25 115 130 240 60
PD8 Optional Optional Optional 34 25 115 130 240 60
PD10 Optional Optional Optional 34 25 115 130 240 60
PD4HF Optional Optional Optional 67 50 170 180 240 130
PD6HF Optional Optional Optional 67 50 210 145 240 130
PD8HF Optional Optional Optional 67 50 230 130 240 130
PD10HF Optional Optional Optional 67 50 230 130 240 130
!
Always wear the correct PPE, when operating or performing maintenance on this attachment. If a hydraulic uid
injection injury occurs, seek emergency medical attention immediately. Explain to medical sta󰀨 that the injury
is the result of pressurised uid injection. Remember even if the point of entry appears as a minor pin hole, this
potentially could be a major injury, especially if not treated in time.
WARNING