Digga PDD - Page 56

56 PM-000251 - Operator’s Manual - PDD-PD50 - June 2022
Hydraulic System
Trouble Possible Cause Remedy
Oil over heating.
Oil pressure too low. Set relief valve to machine specication.
Restriction in line. Inspect and repair.
Auger continually stalling. Limit down pressure.
Drive unit too small. Contact your Digga dealer.
Machine too small. Fit drive unit to larger machine.
Hydraulic oil tank low. Fill oil tank to maximum level.
Insu󰀩cient oil capacity. Fit oil cooler.
Augers
Trouble Possible Cause Remedy
Slow digging speed.
Worn teeth or pilot. Replace the wear parts.
Ground too hard. Contact your Digga dealer.
Low oil ow. Check the machine specications.
Auger too large for the drive unit. Fit larger drive unit.
Machine too small. Fit drive unit to larger machine.
16 Troubleshooting