9
5 Safety Precautions - General Information
Dial Before You Dig
• Service provided in Australia. BeforeUdig is the service provided in New Zealand.
• Never begin work at a new location until the work area has been fully marked for underground
utilities. Buried electrical, telephone, cable wires, gas, water and sewer lines are likely to be present.
Unintentionally disrupting these hidden hazards while working with your loader can result in dangerous
situations and property damage.
• Many countries oer a “dial before you dig” or similar service which advises the location of underground
services in your area. If available also use this service prior to digging, drilling, trenching or any form of
excavating and earthmoving.
You must ensure that underground utilities have been ofcially marked before working in the area. Markings must be valid
according to state law or practice.
CAUTION
Exposure to Respirable Crystalline Silica Dust Along with Other Hazardous Dusts
• It is recommended to use dust suppression, dust collection, and if necessary personal protective
equipment during the operation of this or any other machine attachment that may cause high levels of
dust.
Remove Paint Before Welding or Heating
• Hazardous fumes/dust can be generated when paint is heated by welding, soldering, or using a torch.
Do all work outside or in a well ventilated area and dispose of paint and solvent properly.
• Remove paint before welding or heating. When sanding or grinding paint, avoid breathing the dust. Wear
an approved respirator. If you use solvent or paint stripper, remove stripper with soap and water before
welding. Remove solvent or paint stripper containers and other ammable material from area. Allow
fumes to disperse at least 15 minutes before welding or heating.
To Next Page
Loading...
