Get started Verify product components
AnywhereUSB® Plus User Guide
18
Item Name Description
1 DB9 Console Used to access a console using the RS232 DTEinterface.
2 USB port LEDs
The USB ports support 1.1, 2.0, and 3.1 USB devices.
The LED illuminates as follows, based on the speed of the USB
device:
n 1.1 (Full speed): Yellow
n 2.0 (High speed): Green
n 3.1 (Super speed): Blue
3 ETH 1/2
Connect a Cat 7 STP Ethernet cable. The second Ethernet cable is
optional and used for redundancy.
Note Digi recommends that you use either the Ethernet cable or
the SFP+ module. If both the Ethernet cable and the SFP+ module
are connected, the SFP+ module will have priority.
4 SFP+ 1/2
Connect an SFP transceiver module for fiber connection, such as
Finisar Network FTLX8574D3BCL SFP+. The second SFP+ module is
optional and used for redundancy.
5 Fan1
The LED shows the status of Fan 1:
n Solid green when the fan is running within normal range of
use.
n Solid red if the fan slows down or the Hub is overheating.
5 Fan2
The LED shows the status of Fan 2:
n Solid green when the fan is running within normal range of
use.
n Solid red if the fan slows down or the Hub is overheating.
5 User
LED used for the Find Me feature. When this feature is activated,
the LED blinks orange and then green. You can configure the Find
Me feature in the web UI or by using the findme CL command.
5 PSU1 The LED is blue when the Hub is powered, and solid red if the Hub
is not powered or the supply has failed.
5 PSU2 The LED is blue when the Hub is powered, and solid red if the Hub
is not powered or the supply has failed.
5 Wi-Fi Service Reserved for future use.
5 WWAN1 Service Reserved for future use.
5 WWAN1 Signal Reserved for future use.
6 BT Reserved for future use.