Command descriptions set trace
ConnectPort® LTS Command Reference
145
Examples
Display current trace settings
#> set trace
trace is currently off, using historical mode
syslog is currently off, loghost is ""
logfile is ""
system : ________ web : ________ confmenu : ________
confhdlr : ________ snmp : ________ addp : ________
fwupd : ________ xinetd : ________ connect : ________
ppp : ________ ssh : ________ ssl : ________
pmodem : ________ syschkr : ________ serialp : ________
Enable tracing and print all serial critical, info, and debug data to the screen
#> set trace state=on mode=concurrent mask=serialp:+cid
Enable tracing and send all ssh info and debug data to a syslog server.
#> set trace state=on syslog=on loghost=SYSLOG_IP mask=ssh:+id
Output
Refer to Digi Technical Support for descriptions and interpretations of trace output. Digi provides no
guarantee that trace output is the same across firmware revisions.
See also
n The info commands. These commands display various device statistics that may aid in
troubleshooting.
n The ConnectPort LTS User Guide
n The Digi Support web page, to contact Technical Support, search Digi’s knowledge base, ask a
question on the Support forum, and get diagnostics and utilities.
To Next Page
Loading...
Need help?
General