Command descriptions set network
ConnectPort® LTS Command Reference
72
Sets the mode of device IP v6 address
none
Disable IPv6 address.
static
When selected, the device uses the specified IP address and gateway
address.
dhcp
When selected, the device attempts to use the DHCP v6 protocol to find
an IP address and gateway address.
auto
When selected, the device attempts to use the stateless
autoconfiguration protocol to find an IP address and gateway address.
Default is “none” for both Ethernet interface 1 and 2.
ip_v6= gateway ipv6 address
Sets the device IP v6 address when DHCP or Auto configuration is off. This option is only
applicable if the “mode_v6” option is set to “static.”
gateway_v6= gateway ipv6 address
Sets the network gateway IP address.
ip_6to4tunnel={off|on}
Set this option on to supply 6to4 Tunneling which consists of encapsulating IPv6
packets within IPv4, in effect using IPv4 as a link layer for IPv6 so that ConnectPort LTS
product can reach the remote IPv6 Internet through the existing IPv4 infrastructure.
on
Enable 6to4 Tunneling
off
Disable 6to4 Tunneling.
ip_v4_6to4relay= ipv4 address of remote 6to4 relay
Set the IPv4 address of the remote 6to4 relay device.
ip_v6_v4addr= public ipv4 address for 6to4 tunneling
Set the public IPv4 address to be used for 6to4 tunneling. If not set, current IPv4
address of ConnectPort LTS will be used.
[dns options]
Set DNS(Domain Name Server)-related options for the ConnectPort LTS product, including:
manual_dns={off|on }
Configure manual DNS(Domain Name Server) option for the ConnectPort LTS product
To Next Page
Loading...
Need help?
General