Command descriptions set smtp
ConnectPort® LTS Command Reference
118
set smtp
Purpose
Configures the Simple Mail Transfer Protocol(SMTP) server, or displays current SMTP settings.
Required permissions
For products with two or more users, permissions must be set to “set permissions s-service=read” to
display the SMTP service settings, and “set permissions s-service=rw” to display and change the SMTP
service settings. See "set permissions" for details on setting user permissions for commands.
Syntax
Configure SMTP settings
set smtp [state={off|on}]
[mode={auth|woauth|pop}]
[smtp_server={
hostname
|
ip address
}]
[user=
username
]
[password=
password
]
[from=
email address
]
Display current settings
set smtp
Options
state={off|on}
Specifies whether the SMTP service will be enabled
on
Enable the SMTP service.
off
Disable the SMTP service.
Default is off.
mode={auth | woauth|pop}
Specifies the authentication method for SMTP AUTH authentication.
auth
Enable the SMTP authentication.
woauth
Disable the SMTP authentication.
pop
To Next Page
Loading...
