To Next Page

To Previous Page

Command descriptions set snmp

ConnectPort® LTS Command Reference

122

Disables the accessing of SNMP-managed objects through SNMP v3 protocol.

Enables the accessing of SNMP-managed objects through SNMP v3 protocol.

security_level={auth_nopriv|auth_priv|noauth_nopriv}

Indicates the security level of the user with regard to authentication and privacy

auth_nopriv

Set the security level to use authentication only.

auth_priv

Set the security level to use both authentication and privacy.

noauth_nopriv

Set the security level not to use both authentication and privacy.

snmpv3_permission={get_only|get_set}

Allow SNMP clients to set device settings through SNMP (v3)

get_only

Disabled the capability for users to issue SNMP “set” commands uses use of SNMP

read-only for the ConnectPort LTS product.

get_set

Enabled the capability for users to issue SNMP “set” commands uses use of SNMP read-

only for the ConnectPort LTS product.

auth_user=username

SNMPv3 User name who is authenticated to communicate with the SNMP engine.

auth_protocol={md5|sha}

Specifies the authentication protocol algorithm.

md5

Set MD5 algorithm as authentication protocol.

sha

Set SHA algorithm as authentication protocol.

auth_pwd=password

Set the password for authentication.

priv_protocol={des|aes}]

Specifies the privacy protocol algorithm.

des

Set DES algorithm as privacy protocol.

aes

Set AES algorithm as privacy protocol.

Digi ConnectPort LTS8 Command Reference

Other manuals for Digi ConnectPort LTS8