Digi ConnectPort LTS8 - Page 20

Command descriptions boot
ConnectPort® LTS Command Reference
20
Examples
Restore configuration defaults
This example reloads the firmware stored in flash ROM and resets the configuration to factory
defaults then reboots the device.
#> boot action=factory
Reboot using the current firmware and configuration
This example reboots the device and uses the current firmware and configuration stored in flash ROM.
#> boot action=reset
Reboot using firmware from a boot host
This example loads the firmware stored on the TFTP host into flash ROM. A reboot is required to use
the new firmware.
#> boot load=10.0.0.1:firmware.bin
See also
revert