Command descriptions set profile
ConnectPort® LTS Command Reference
97
n For a user to display the profile settings for any line, and set modem emulation settings for the
line on which the user is logged in: “set permissions s-profile=w-self-r”
n For a user to display and set the profile settings on any line: “set permissions s-profile=rw”
See "set permissions" for details on setting user permissions for commands.
Syntax
Configure port profile settings
set profile port=port
profile=
profile name
[portsharing={on|off}]
Display current port profile settings for all available serial ports
set profile
Display current port profile settings for a particular serial port
set profile port=port
Options
port=port
The serial port number or range of serial ports associated with the port profile.
Required when configuring port profiles.
profile=profile name
The port profile to use for the serial port. Required when configuring port profiles. Choosing a
particular port profile causes the serial port’s configuration to be reset to defaults, and then for the
default settings for that port profile to take effect.
Depending on the port-profile choices available for the device, the value of “profile” can be one of the
following:
console_management
Associates the Console Management port profile with the port.
modem_emulation
Associates the Modem Emulation port profile with the port.
realport
Associates the RealPort port profile with the port.
tcp_sockets
Associates the TCP Sockets port profile with the port.
tunneling
Associates the Serial Bridge port profile with the port.
udp_sockets
To Next Page
Loading...
Need help?
General