SETTING
TWO
SX-D PLATFORM
SCALE 1: SCALE 2:
NormaUv
00:
1
00: Internal Scale 1
Set
01: Internal
2
Internal Scale 2
0001
External Scale
External Scale
11: Force Balance
11: Force Balance
SCALE 3:
SCALE 4:
Normatfv
00: Internal
1
1
Set
Scale 2 01:
Scale 2
10: External Scale
10:
Scale
Force Balance
11: Force Balance
The SX-D
Would Be Plugged Into The SX-1 Load Cell
Using
SX-D Platform In Scale 1
Connector No Power Supply Will Be Necessary As Power Will Be
Supplied By The Platform.
In This Case Other Specs That Will Need To Be Set Are As Follows:
and Measures
To enter this mode, enter the numeric keys
while
pressing the Re-zero Key. The Span Switch must
to enter this
Spec No. 3
2 Bit 1
Display
Scale 1)
00:2 10:5
11.10
Display
2)
00:2 10:5
11
21 Decimal
(Scale
: 00000 010 :
100 :
001 :
22
Weight Decimal Point Position (Scale 2}
000 : 00000 010 : 000 00 100 : 0.0000
011
23
Set
0 01 1
Display Resolution
1/10.000
01
11
Used
Zero Setting Range
00 :
Unlimited 10 :
FS
01
FS 11 : Not Avail.
ooOo
Scale Starting Method
0 : Automatic
1 : Manual
Mode
protected by
Span Switch
0 : No 1 : Yes
Scale Type
1 : Double
Scale
Gross Mode Available
0 : Yes
1
32
1 01 1
Calibration Mode
protected by Span Switch
0 : Yes 1 : No
Battery Low
Lamp
Auto
from
Add Mode
External Load Cell (Scare 3)
0: No
33
0
Over Weight Mask at
1:+9d
Weight Decimal Point Position (Scale 3)
000 : 00000 010 : 000.00 100 : 0.0000
001
0000.0 011
00.000
36
00
Minimum
10
11
Scale
5
10
Board (For
3)
00 : Normal
01 : Prevent from Small vibration
fast change
display
10 : Prevent from Medium vibration
: Prevent from Large slow change in display
es 1 To Select The Minimum Display And Decimal
Divide Capacity 8y The Display Resolution
Selected In Spec23.
2 In This Case Scale 1
2 Will Be Turned On.
59
IF YOU ARE SETTING UP A TWO CHANNEL SCALE WITH PLATFORM CONTAINING TWO LOAD CELLS
BUILT-IN, THIS IS
THE SPECS
17 SHOULD BE SET.
To Next Page
Loading...
