Digi DI-162 - Main Operation Procedures; SPEC Setting Key Operations

15
2):As introduced at the previous section, there are 2 kinds of
key-operation when entering SPEC setting mode.
a . [REZERO] + [T] [T] [T] ------- for SPEC No.0-No.19
b . [REZERO] + [Í] [Í] [Í] -------for SPEC No.20-No.39
When SPEC setting operation , the following display will
appear.
Bit3 Bit2 Bit1 Bit0
1 1 0 0
SPEC data
*The SPEC No. such as “SP01” and SPEC data such as “1100”
alternately display at start.
*After any key is pressed , it stop alternately display.
*The blinking digit indicates the current programmable
position.
When setting or changing SPEC data, key switches function are
as follows.
[REZERO] -----------SPEC No. skips each time this key is
pressed.
[ T ] ------------ To renew the data and exit this mode.
[Í] ------------ To move digit position. The blinking position
All manuals and user guides at all-guides.com
all-guides.com