Digi One IAP User Manual

Configure the Digi One IAP using IAprofiles DF1 profile: serial-connected master
Digi One IAP Family User Guide
13
Configuration requirements
The serial port connection must be configured for the protocol required by the slave, in this case, DF1
Full-Duplex.
The network connection usually does not require configuration. The only exception is if the master
requires COM port redirection. In that case, the master is an application that resides on a PC, such as
a Microsoft Windows system, and communicates only with devices on COM ports.
Setup information
n To configure the serial port of the device server for DF1 Full-Duplex, see Configure a serial-
connected master: TCP/UDP sockets.
n To set up a PC and the device server for COM port redirection using RealPort, see Set up
COMport redirection.
DF1 profile: serial-connected master
Use the DF1 Serial-Connected Master profile to connect a master device using the DF1 Full-Duplex and
protocols to the serial port.
Configuration requirements
The serial port connection must be configured for the protocol required by the master, in this case,
DF1 Full-Duplex. If the remote slave supports TCP socket communication, which is the case if the
remote slave is connected to another device, Digi recommends this option. For DF1 Full-Duplex users,
Allen Bradley Ethernet and Ethernet/IP are other supported network options.
Setup information
n To configure the port for DF1 Full-Duplex and the network for TCP socket communication, see
Configure a serial-connected master: TCP/UDP sockets,
n To configure the port for DF1 Full-Duplex and the network for Allen Bradley Ethernet or
Ethernet IP, see Configure a serial-connected master: generic procedure.
Omron family profile: serial-connected slave
Use this profile to connect a slave device (or devices) using one of the Omron serial port protocols,
Hostlink, FINS, or CompoWay/F.

Digi One IAP Specifications

General

Brand	Digi
Model	One IAP
Category	Server
Language	English