Hardware information Safety considerations and warnings
Digi One IAP Family User Guide
27
n UL 60950
n EN60950
Safety considerations and warnings
n Do not attempt to service the power supply that comes with the Digi One
IAP. This sealed unit contains no user-serviceable parts or adjustments. Do
not open or tamper with the power supply.
n Carefully inspect the work area in which the Digi One IAP will be located to
ensure against hazards such as damp floors, ungrounded power extension
cords, and missing ground connections.
n Before operating the Digi One IAP, ensure that external power sources
comply with the requirements listed in the specifications. If you are not
sure of the type of power source, contact your dealer or power company.
n Ensure that the ampere rating of all equipment plugged into wall outlets
does not exceed the capacity of the outlet.
n Ensure that the cover is secure on completion of installation to reduce
safety hazards.
Other considerations
n If you require an extension cord, ensure that the ampere rating of all equipment plugged into
the extension cord does not exceed the ampere rating of the cord.
n If the Digi One IAP is exposed to moisture or condensation, disconnect it from the power
source immediately and obtain service assistance.
n If the Digi One IAP exhibits unexpected behavior, such as smoking or becoming extremely hot,
disconnect it from power sources immediately and then obtain service assistance.
Environmental considerations and cautions
To ensure safe and efficient operation of your Digi device, observe these
environmental recommendations and cautions:
n Do not position the Digi device near high-powered radio transmitters or
electrical equipment, such as electrical motors or air conditioners.
Interference from electrical equipment can cause intermittent failures.
n Do not install the device in areas where condensation, water, or other
liquids may be present. These may cause safety hazards and equipment
failure.
To Previous Page
Loading...
Need help?
General