SM 5100 SOFTWARE SETTING
These two twisted cable obey the EIT/TIA 568 standard.
T568B line series
1 Orange & White
2 Orange
3 Green &White
4 Blue
5 Blue & White
6 Green
7 Brown & White
8 Brown
T568A line series
1 Green &White
2 Green
3 Orange & White
4 Blue
5 Blue & White
6 Orange
7 Brown & White
8 Brown
crossing twisted cable: one end with T568A line series, another with T568B line
series
normal twisted cable: two ends both with T568B line series
2 .PC Setting & Programmer Version
We use “Mini Programmer (Version 2.00)” as the tool to update the scale. As it
needs a default visual IP address for the PC by this kind of update method, You must
set your PC’s IP address within the range of 10.10.10.1-----10.10.10.240, before you
start the software to update the scale.
If you don’t set the IP address like this, you can see an alarm window as Pic. 1 when
you start “Mini Programmer”.
Pic. 1
2. Updating Steps
1) How to start ethernet updating?
A. Turn on the switch on the bottom of the scale.
B. Power off the scale by pressing On/Off Key.
C. After that, press and hold [Re-Zero] and [Preset 22], then start the scale by
pressing the On/Off Key.
D. The screen will display the version of the current boot program for two seconds.
E. Only in new versions(version of the boot program newer than 1.10), you
can choose 2-ethernet.
2) Display on the scale’s screen
A. If you choose 2 and the scale’s connection is correct, it will display “waiting for
connect”.
B. Then the message on the scale’s screen is “getting IP address”.
C. After this, it will display “001 scale ready update”.
D. You can’t stop it unless you press On/Off key. If you want to continue
updating. You also don’t need to press any key on the scale until Mini
Programmer begin to run.
18
To Next Page
Loading...
Need help?
General
