Digi SM-5300 - Page 230

Tray File
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
14.2 Copy a Tray File
M o d e l S M - 5 3 00 O p e r a t i o n M a n u a l | 229
14.2 Copy a Tray File
The programmed Country data can be easily copied into a new Tray. This function is very useful to
save time or avoid mistake for the similar Tray data programming.
OPERATION
DISPLAY
1.
In Country Programming Mode, enter a new
Tray number. (e.g. 9)
Touch [COPY] key.
Note: Touch [ARROW DOWN] or [ARROW
UP] for more selection.
2.
Touch the desired Tray data to copy from.
(e.g. Tray 8)
Note: Change the necessary data if required.
3.
Touch [SAVE] key to save the programmed
data.
Note: Touch [MENU] key to escape saving
data.