Digi SM-5300 - Page 232

Tray File
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
14.4 Delete a Programmed Tray File
M o d e l S M - 5 3 00 O p e r a t i o n M a n u a l | 231
14.4 Delete a Programmed Tray File
OPERATION
DISPLAY
1.
In Tray Programming Mode, enter the Tray
Number to be deleted. (e.g. Tray 0)
Note: Also can browse and touch the
Programmed Tray (without entering the
Programmed Number)
2.
Touch [DELETE] key.
3.
Touch [YES] key to delete the data.
Note: Touch [NO] key to escape deleting the
data.
Note: Another method of deleting the Programmed is by entering the Programmed file and touches the
DELETE key.