––––––––––––––––––––––––––––––––––––––––––––––––––––
23.1 Program Cutting Hall File
M o d e l S M - 5 3 00 O p e r a t i o n M a n u a l | 292
CUTTING HALL FILE
23.1 Program Cutting Hall File
Cutting Hall is used to program Cutting Hall Name for Traceability Information programming and
printed on Label. Since standard format does not have a print area set for Cutting Hall, the Cutting
Hall cannot be printed when using these formats. To print Cutting Hall on the label, it is required to
use a Free Format with a Cutting Hall print area programmed. Maximum 9999 Cutting Hall can be
programmed and maximum 16 characters can be entered per Cutting Hall File, each with 1 line.
Note: SPEC 146A008 “Traceability” (in Module Spec) must be enabled in advance.
Touch [PROGRAMMING] key follow by
[TRACEABILITY] key to enter to
Programming Mode.
Touch [CUTTING HALL] key.
Note:
1. Touch [MENU] key to return back to
Programming Mode.
2. All programmed Cutting Hall File will be
listed in CUTTING HALL PROGRAMMING
Display Screen.
3. Display Screen also used to browse
existing Cutting Hall Files using the scroll
bar and to select file for modification
To Next Page
Loading...
Need help?
General
