Digi SM-5300 - Page 298

Cutting Hall File
––––––––––––––––––––––––––––––––––––––––––––––––––––
23.4 Delete a Programmed Cutting Hall File
M o d e l S M - 5 3 00 O p e r a t i o n M a n u a l | 297
23.4 Delete a Programmed Cutting Hall File
OPERATION
DISPLAY
1.
In Cutting Hall Programming Mode, enter the
Cutting Hall Number to be deleted. (e.g.
Cutting Hall 8)
Note: Also can browse and touch the
Programmed Cutting Hall (without
entering the Programmed Cutting Hall
Number)
2.
Touch [DELETE] key.
3.
Touch [YES] key to delete the data.
Note: Touch [NO] key to escape deleting the
data.
Note: Another method of deleting the Cutting Hall is by entering the Cutting Hall file and touches the DELETE
key.