Digi XBee 3 Hardware Reference Manual

Regulatory information Australia (RCM)/New Zealand
Digi XBee® 3 RF Module Hardware Reference Manual
54
requise pour chaque type d'antenne. Les types d'antenne non inclus dans cette liste, ou dont le gain
est supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitation de l'émetteur.
Detachable Antenna
Under Industry Canada regulations, this radio transmitter may operate using only an antenna of a
type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (EIRP) is not more than that necessary for successful
communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peutfonctionner
avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvépour l'émetteur par Industrie
Canada. Dans le but de réduire les risques de brouillageradioélectrique à l'intention des autres
utilisateurs, il faut choisir le type d'antenne etson gain de sorte que la puissance isotrope rayonnée
équivalente (p.i.r.e.) ne dépassepas l'intensité nécessaire àl'établissement d'une communication
satisfaisante.
Australia (RCM)/New Zealand
XBee 3 and XBee 3-PROmodules comply with requirements to be used in end products in Australia
and New Zealand. All products with EMC and radio communications must have registered RCM and R-
NZ marks. Registration to use the compliance mark will only be accepted from Australia or New
Zealand manufacturers or importers, or their agents.
In order to have an RCM or R-NZ mark on an end product, a company must comply with a or b below.
a. have a company presence in Australia or New Zealand.
b. have a company/distributor/agent in Australia or New Zealand that will sponsor the importing
of the end product.
Contact Digi for questions related to locating a contact in Australia and New Zealand.
Japan (TELEC)
The XBee 3 (not XBee 3-PRO) complies with Japan MIC Article 2 Paragraph 1, Item 19.
The customer product is subject to testing for conformity to the same Japanese standard.
Brazil ANATEL
The XBee 3 ZigBee, DigiMesh and 802.15.4 radio modules comply with the requirements of ANATEL to
be used in Brazil. The customer's product is subject to testing for conformity to the same Brazilian
standards.

Digi XBee 3 Specifications

General

Brand	Digi
Model	XBee 3
Category	Modem
Language	English