2.4 Barometer
kbar setup
2.5 Thermometer
2.6 Time/Chrono
hour
min day mont
year setup
To select on the multifunction display the barometer reading press the
key . In case of small errors is possible to calibrate the
barometer editing the parameter n.9 (in 0.1 mB steps) in
submenu.
To select on the multifunction display the thermometer reading press
the key.
To select on the multifunction display the Time (clock) or the Chrono
(chronometer) press the key. In order to reset the Chrono,
when displayed, press with long pressure the key.
To adjust the Date and Time modify following parameters n.10
(hour), n.11 (minutes), n.12 (day), n.13 (month), n.14
(year), in the submenu.
In order to set the multifunction display to show the battery voltmeter
press the keys (example " " means 2.8 Volts )
The batteries level is continually monitored and is displayed on the
fourth digital display. The level is displayed as a percentage from 0 to
90 in 10% steps (for example "b " indicates that the batteries are at
80% of the full level.)
or
or
or
Warning!!! The wrong use of this function makes the
measurements of the barometer and altimeters less accurate.
2.7 Batteries Voltmeter
2.8 Batteries Level
V 2.8
Warning ! The Vl100 instrument turns off when the battery level falls
below 1.9 Volts.
80
or
Page 6
To Next Page
Loading...
Need help?
General
