Digilent Arty Z7 - Features; ZYNQ Processor; Memory; Power

Arty Z7 Reference Manual Transfer Multisort Elektronik / tme.eu 3
Features
• ZYNQ Processor
o 650MHz dual-core Cortex-A9 processor
o DDR3 memory controller with 8 DMA channels and 4 High Performance
AXI3 Slave ports
o High-bandwidth peripheral controllers: 1G Ethernet, USB 2.0, SDIO
o Low-bandwidth peripheral controller: SPI, UART, CAN, I2C
o Programmable from JTAG, Quad-SPI flash, and microSD card
o Programmable logic equivalent to Artix-7 FPGA
• Memory
o 512MB DDR3 with 16-bit bus @ 1050Mbps
o 16MB Quad-SPI Flash with factory programmed 48-bit globally unique EUI-
48/64™ compatible identifier
o microSD slot
• Power
o Powered from USB or any 7V-15V external power source
• USB and Ethernet
o Gigabit Ethernet PHY
o USB-JTAG Programming circuitry
o USB-UART bridge
o USB OTG PHY (supports host only)
• Audio and Video
o HDMI sink port (input)
o HDMI source port (output)
o PWM driven mono audio output with 3.5mm jack
• Switches, Push-buttons, and LEDs
o 4 push-buttons
o 2 slide switches
o 4 LEDs
o 2 RGB LEDs
• Expansion Connectors
o Two Pmod ports
▪ 16 Total FPGA I/O
o Arduino/chipKIT Shield connector
▪ Up to 49 Total FPGA I/O (see table below)
▪ 6 Single-ended 0-3.3V Analog inputs to XADC
▪ 4 Differential 0-1.0V Analog inputs to XADC