Digilock Curve - Programming Instructions - Adding Keys; Add Manager Keys; Programming Instructions - Replacing Keys; Replace the Programming Key

PRODUCT GUIDE
Keypad | Basic & Advanced
3
The locks must be reprogrammed to prevent lost/stolen keys from operating a lock.
Add Manager Keys
Manager Keys can be programmed to the locks at any time.
Note the order or serial number (found on the lock’s rear unit). Contact Digilock Support to purchase a replacement
Programming Key.
Collect all remaining and any
new Manager Keys.
Go to any lock operated by the
lost/stolen Manager Keys.
Press
= ` 55 `
.
The LED will turn on.
Insert the Programming Key.
A two-tone beep will be heard.
Reinsert the Programming Key
again. Three sets of two-tone
beeps will be heard and the
LED will turn off.
All previously programmed
Manager Keys will be erased.
Follow instructions to Add
Manager Keys to program the
remaining and replacement
Manager Keys to the locks.
Go to a lock requiring
additional Manager Keys.
Press
= ` 55 `
.
The LED will turn on.
Insert the Programming Key.
A two-tone beep will be heard.
Insert each additional Manager
Key one at a time.
A two-beep will be heard
for each Manager Key
programmed.
Insert the Programming Key.
A two-tone beep will be heard
and the LED will turn off.
Repeat above steps for each
lock or follow instructions to
Express Register Manager Keys
to quickly program multiple
locks to operate with the same
Manager Keys.
To Replace the Programming Key
To Replace the Manager Keys
1 2
1
1
3
3
2
2
4
4
PROGRAMMING INSTRUCTIONS - ADDING KEYS
PROGRAMMING INSTRUCTIONS - REPLACING KEYS