Digisol DG-WA3000N User Manual

DG-WA3000N
300Mbps Wireless LAN Access Point
User Manual
V1.1
2012-02-15
As our products undergo continuous development the specifications are subject to change without prior notice

Digisol DG-WA3000N Specifications

General

Wireless Standards	IEEE 802.11b/g/n
Frequency Band	2.4 GHz
Maximum Data Rate	300 Mbps
Number of Antennas	2
Antenna Gain	5 dBi
Security	WEP, WPA, WPA2
Antenna Type	External
Ports	1 x 10/100 Mbps Ethernet
Power Supply	5V DC
Operating Modes	Access Point, Repeater, Client

Summary

1-2 Safety Information

Safety Instructions

2. System and Network Setup

2-1 Hardware and Software Installation

Access Point Network Configuration

Instructions for configuring the Access Point's IP address and selecting its operating mode.

Configure Wireless Network Settings

Configure Wireless Security

Guide to setting up wireless security, recommending WPA2-PSK (AES) for data safety.

Connecting via Web Browser

Connecting to Web Management Interface

Select Access Point Operating Mode

2-5 WPS Setting

Guides on using WPS for simple and secure wireless client connection to the Access Point.

2-7 Wireless Security

Outlines available wireless security levels: Disable, WEP, WPA Pre-shared Key, and WPA RADIUS.

2-8 Radius Server Configuration

2-9 MAC Filtering Setup

3. Advanced Configuration

3-1 Configuration Backup and Restore

3-2 Firmware Upgrade

Step-by-step guide for upgrading the Access Point's firmware to the latest version.

3-3 System Reset (Restart)

Instructions on how to reset the Access Point to its factory default settings.

4. Appendix

4-2 Troubleshooting

Provides common troubleshooting steps and solutions for problems encountered with the Access Point.