CheXpress
®
CX30 User Manual
Rev 042516
Page | 8
CheXpress CX30 Initial Setup
New User Notice
PLEASE NOTE: Do not connect the ‘USB’ cable from the scanner to your PC before installing the ‘drivers’ or
the ‘scanning application / software’. Digital Check does not provide scanning software. Please contact your
bank or other solution provider for further assistance with installing the driver or getting the scanning software
set up or installed.
Digital Check provides only an optional driver installation utility and a separate demonstration program.
See the ‘Installing the Optional USB Driver’ section or the ‘Installing ScanLite2’ section for additional
information.
Unboxing the CheXpress CX30
Lay the box on its side and slide out the packaging and scanner. Lift off the top plastic insert (the ‘USB’ cable is
inside), then lift the scanner from the bottom insert.
To Next Page
Need help?
General
