Operation 13
appropriate number between 1 and 0 (i.e.
1=11,2=12,3=13,4=14, etc.. 0 is Preset
20).
2. The LCD will display the message Pxx
Saved, once the Preset is stored, (xx is the
Preset Number).
Storing A Preset FM)
To store a FM Preset using the Remote Control
Unit or front panel controls do the following:
1. Press the TUNE button. The DRR-103 will
tune to an FM station.
2. Press the Å or Æ navigation buttons
to select a FREE Preset location. If the
currently selected Preset is already
allocated, but is no longer required, it can
be “overwritten” with a new Preset.
3. Press the Å or Æ to select one of twenty
preset locations displayed. If the Preset
is not programmed, the display shows
"Pxx FREE", (xx is the Preset Number).
While the "Pxx FREE" is flashing, press
the ENTER button to store it as a Preset.
The message "Pxx SAVED" is displayed.
If the currently selected Preset is already
allocated, but is no longer required, it can
be “overwritten” with a new Preset.
Tuning To A Station Using A Stored Preset
(DAB & FM)
You can tune to any station using a stored Preset
in either DAB or FM modes. Twenty presets are
available for each mode.
1. Press the Å or Æ buttons. This will step
through each Preset. The LCD will show
the Station ID associated with the preset
number. Alternatively, pressing and
holding the Å or Æ buttons will quickly
scroll through all Presets. Releasing the
button selects the required Preset.
2. An alternative means of selecting a Preset
by directly entering the Preset number
using the Remote Control Unit is as
follows.
3. There are two Preset Groups, 1-10 and
11-20., To select a stored Preset within
the first Preset Group (1-10), press the
required Preset number between 1 and 0
- i.e. 1,2,3,4,5,6,7,8,9 0. 0 is Preset 10.
4. To select a stored Preset within the
second Preset Group (11-20), press the
10+ button. The Preset Group 11-20 is
shown on the front panel LCD. To select a
preset between 11-20 press the required
Preset number between 1 and 0 (i.e.
1=11,2=12,3=13,4=14, etc.. 0 is Preset
20).
Tuning To A DAB Station And Not Using The
Stored Preset Function
To tune to a Station without using the stored
Preset:
1. Press the Ç or È navigation buttons on
the front panel or remote control unit.
The next valid station is then automatically
selected.
Recalling/Selecting An FM Station And Not
Using The Preset Function
1. To select an FM station and not use the
Preset function, press the TUNE button
on the front panel or remote control unit.
The next valid station is then automatically
selected.
Introduction To Live PAUSE
The DRR-103 provides an extended feature which
allows “temporary recording” of the current
program you are listening to. This is referred to
as Live PAUSE. Live PAUSE is typically used if
the listener needs or wants to defer the current
listening of a program. Once activated, Live
PAUSE then allows the user to resume listening
to the program from the time it was paused.
The maximum recording period for Live PAUSE
is four hours with the total active duration of
twelve hours. The active duration is automatically
terminated after twelve hours unless the STOP
<
button is otherwise pressed.
To Next Page
Loading...