Connections
The Bass Multi Chorus has a single input and a pair of outputs. Out 1
is used if the Bass Multi Chorus is being connected to only one amplifier
or mixer channel. Out 2 is used for stereo operation. Connect Out 1
to the first amplifier or mixer channel panned hard left and Out 2 to
the second amplifier or mixer channel panned hard right.
The Bass Multi Chorus also has built-in CIT™ cabinet modeling. This is
a useful tool when running a distortion pedal into the Bass Multi Chorus
and then running direct into a mixer or recorder. This creates a
through-an-amplifier sound without having to use a bass amp. The CIT
model is based off a 4x10 cabinet.
To Enable CIT™ Cabinet Modeling:
Press the pedal down and apply power (connect a 1/4” cable to the Bass
Multi Chorus input or connect the PS200R power supply to the AC
adapter jack).
CIT™ cabinet modeling has to be turned on each time you apply power
to the Bass Multi Chorus.
To Next Page
Loading...
Need help?
General
