Selecting a channel
Before selecting a channel for transmitting, always
listen on it and ensure it is not already being used.
Always avoid selecting a busy channel when the unit
keeps on receiving signal from unknown party. The RX
icon will be displayed.
The factory default start up channel is channel 1 and
sub-channel 00.
Press 5/6 to select the desired channel.
Channel Banks
The unit has three banks(groups) of channels to select
from:
1
CB UHF CB + user programmable RX channels
2
POL Pre-programmed Police frequencies
2
FIRE Pre-programmed Fire & Ambulance frequencies
When the CB icon is showing the 80 UHF CB and any
user programmed RX channels will be available for
selection or scanning. The 80 UHF CB channels are
numbered 01-80. The user programmable RX channels
are numbered 81-180 and only show, in the
CTCSS/DCS code area, when programmed.
When the POL icon is showing then pre-programmed
police frequencies will be available. When the FIRE
icon is showing then pre-programmed fire & ambulance
frequencies do not have channel numbers, instead PO
appears in the channel display for a police frequency
and FI appears for a fire or ambulance frequency.
Press PO/FI to select the desired channel banks combination.
The channel banks can be selected as follows:
---- CB ----
POL ---- ----
---- ---- FIRE
POL ---- FIRE
POL CB ----
---- CB FIRE
POL CB FIRE
NOTE
!
1
in 12.5kHz step.
2
Police, Fire & Ambulance reception is unencrypted analogue.
For Australia, Channels 05 and 35 are reserved for Emergency calls.
Available frequencies & channels are within 400-520MHz band only
-10-
To Next Page
Loading...
Need help?
General
