Receiving a signal
The unit is continuously in RECEIVE mode when it is on and not transmitting.
When you receive a signal on the current channel, the RX icon will appear.
Transmitting
The unit transmits only on UHF-CB
channels.
Press and hold the PTT button to transmit
your voice: the TX icon will appear;
While holding the PTT button, speak into
the microphone using a normal tone of
voice. Hold the microphone in a vertical
position about 5 to 7 cm from the mouth.
PTT
CALL
INST
Programming the Instant Priority
Channel
Press 5or 6button to select the Priority
Channel you prefer.
Press and hold INST button to store the
new setting .INST icon appears.
Momentarily press INST to return to the
Instant channel, press INST again to
return to the previous channel.
-11-
To Next Page
Loading...