Need help?Do you have a question about the DigiTech DC-1122 and is the answer not in the manual?
General| Brand | DigiTech |
|---|---|
| Model | DC-1122 |
| Category | Transceiver |
| Language | English |
Lists key features of the DC-1122 UHF CB Radio, including transmission type, frequency range, power output, and various functions.
Details the physical controls and connection ports on the base unit of the radio, identified by numbers.
Identifies and describes the buttons and components of the radio's microphone, including the LCD display and PTT button.
Explains the various icons and indicators shown on the radio's LCD screen, such as TX, RX, and channel information.
Provides instructions on how to properly connect the microphone to the radio's MIC jack, including locking and dust sealing.
Guides users on how to mount the radio's cradle in a vehicle, considering sound output and avoiding heat sources.
Explains two methods for mounting the microphone hanger: using screws or double-sided tape.
Instructs users to press and hold the power button to turn the radio on or off.
Details the voltage operating range and alerts for low or high voltage conditions, including potential damage.
Describes the three channel banks (CB, POL, FIRE) available for selection and scanning on the radio.
Explains how to transmit using the PTT button, microphone position, and voice tone.
Details how to select, store, and return to the instant priority channel using the INST button.
Explains how to set DCS codes, noting they follow CTCSS codes and require matching for communication.
Describes how to use the M.SEL button to check and select a desired memory channel.
Explains how to activate Dual Watch mode using the DW button to monitor two channels simultaneously.
Guides users on how to set the radio to Duplex mode using the MENU and directional buttons.
Explains how to activate Priority Watch via the MENU button to monitor the priority channel during scanning.
Details how to add or remove channels to/from scan memory using the MEM button.
Describes the default OS mode for continuous scanning and how it stops on active channels.
Explains GS mode, channel addition, and priority watch functionality during scanning.
Guides on setting the call tone melody, selecting from 0 to 10 songs via the MENU button.
Explains how to prevent transmission on busy channels using the Busy Channel Lockout feature.
Details how to enable or disable the Roger Beep feature using the MENU button.
Explains how to turn the key beep sound ON or OFF using the MENU button.
Describes how to select the LCD backlight colour from three options: orange, red, or green.
Provides step-by-step instructions for manually programming receive-only channels (RX channels).
Guides on storing Police or Fire frequencies into RX channels using specific buttons and scan modes.
To Next Page
