Group Scan (GS) Mode
GS Mode has no channels in the SCAN Memory by
default. Channels must be added to the GS SCAN
Memory before group scan can start. To
add/remove channels from GS SCAN Memory.
Includes the accessory feature priority Watch
which allows you to monitor the Instant Priority
Channel while scanning.
GS Scanning checks the Instant Priority Channel
for activity regularly when Priority Watch is ON.
If the Priority Channel becomes active the unit will
stay on that channel for as long as the signal is
present. If the received signal ceases, Priority
Scanning continues after 3 seconds.
If scanning stops on a channel which is not a
Priority Channel, UHF CB Radio will continue
monitoring the Priority Channel for activity while
listing to the active one.
To select GS Scan Mode:
1.Press MENU three times, the GS setting flashes.
2.Press 5/6to change the setting between ON
and OFF.
Call Tone setting
Press MENU four times, the call icon flashes.
Press 5/6to change the setting between 0 to 10.
Busy Channel Lockout
If the channel is already in use, you can prevent the UHF CB Radio from
transmitting. This is particularly important when using CTCSS/DCS.
Press MENU five times, the Busy icon flashes.
Press 5/6to change the setting between ON and OFF.
Roger Beep
Press MENU six times, the roger beep icon flashes.
Press 5/6to change the setting between ON and OFF.
-16-
To Next Page
Loading...