DigiTech DC-1122 - Key Beep; Backlight Colour; 100 User Programmable RX Channels; Manually Programme a RX Channel

Key Beep
Press MENU seven times, the key beep setting flashes.
Press 5/6to change the setting between ON and OFF.
Backlight Colour
Press MENU eight times, the backlight colour setting flashes.
Press 5/6to select colour (3 colours: orange /red /green).

100 User Programmable RX Channels
The unit has 100 receive only channels (Ch81 to Ch180) which can be
programmed with frequencies ranging from 400-520MHz (in 12.5kHz steps).
The extra RX channels only appear, as part of the CB channel bank, when a
frequency has b een programmed to a channel. There are two ways to
programme RX channels:
If you know the frequency you may manually programme it to a channel.
Store a Police or Fire (& Ambulance) frequency to a channel.
Manually Programme a RX Channel
In CB channel (UHF CB channel):
Press and hold MENU. the lowest available empty RX channel will flash;
Press 5/6 if you wish to select another RX channel;
Press SQ to begin the frequency edit. The MHZ digit range flashes. Use
MENU to shift between MHZ range (between 400-520MHz) & kHz range (in
12.5kHz steps);
Press 5/6to select the desired frequency within MHz & kHz ranges.
When finished press SQ. The channel flashes to enable selection for
programming of next channel if desired.
Store a Police or Fire frequency to a RX channel
Select the Police or Fire ( & Ambulance) channels group by pressing
CTCSS/DCS, and then select a desired frequency using 5/6.
Or during SCAN, when scan stops on a Police or Fire ( & Ambulance) frequency
which you wish to store press MENU to stay on that frequency.
Press and hold MENU. the lowest available empty RX channel will appear,
alternating with the selected Police and Fire (& Ambulance) frequency.
Change the RX channel using 5/6 if desired.
-17-