28
Recording a Loop Using Auto Record
The JamMan
®
Stereo has an Auto Record feature that automatically starts
recording when signal is detected at any of the JamMan Stereo’s inputs.
NOTE: The maximum loop time the JamMan Stereo can record or play is
10 minutes. You can’t auto-record on an existing loop; Auto Record is only
available when an empty loop memory is selected.
Here is how to use Auto Record when recording a loop.
Select an empty memory location using the 1. LOOP SELECT knob or
LOOP UP/LOOP DOWN footswitches (the LOOP and SINGLE LEDs will be
off). If the CARD MEM LED is lit, you have selected an empty location
on the optional memory card.
Press the 2. AUTO REC button so it is lit.
Press the 3. REC/PLAY/OVERDUB footswitch to arm record. The
REC/PLAY/OVERDUB footswitch and RECORD status LEDs will be quickly
flashing red indicating the JamMan Stereo is armed for recording.
Begin playing a phrase on your guitar. The 4. REC/PLAY/OVERDUB
footswitch and RECORD status LEDs will light solid red to indicate
recording is now taking place.
When you are finished recording, press the 5. REC/PLAY/OVERDUB
footswitch once to set the loop point and have the phrase play back
in a repeating loop. The REC/PLAY/OVERDUB footswitch and PLAY status
LEDs will light solid green.
Press the 6. TEMPO/STOP footswitch to stop the loop playback.
Once you are finished recording, the STORE button will be lit indicating the
phrase must be stored to memory to be recalled later.
To Next Page
Loading...
Need help?
General
