EasyManuals Logo
Home>DigiTech>Computer Hardware>RP355

DigiTech RP355 User Manual

DigiTech RP355
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
10
Applying Power
Before applying power to anything, set your amp(s) to a clean tone and set the tone controls to
a flat EQ response (on most amps, this would be 0 or 5 on the tone controls). Then follow the
steps listed below.
1. Turn the amp volume all the way down.
2. Connect the plug of the PS0913B power supply to the power jack on the rear panel of the
RP355.
3. Connect the other end of the PS0913B power supply to an AC outlet. Turn the RP355’s Mas-
ter Level knob (Knob 6) down to “0”.
4. Turn the power of your amplifier(s) to the on position and adjust the volume(s) to a normal
playing level.
5. Gradually increase the RP355’s Master Level knob to achieve the desired volume.
DISTORTION
BYPASS
STOMP Mode
DELAY
AMP A-B
4. Turn amp volume up
1. Turn amp volume down
2. Connect PS0913B to power jack
3. Connect PS0913B
to AC outlet and
turn the RP355’s
Master Level to “0”
5. Turn the RP355’s Master Level
to the desired listening volume

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DigiTech RP355 and is the answer not in the manual?

DigiTech RP355 Specifications

General IconGeneral
BrandDigiTech
ModelRP355
CategoryComputer Hardware
LanguageEnglish

Related product manuals