DigiTech RP355 User Manual

20
Rotary Speaker ()
The Rotary Speaker emulates a device that included a spinning horn and woofer. The rotation of
these two speakers produced an interesting combination of the sound panning from side to side.
This produced a slight pitch change due to the speed of the sound coming towards, and then
going away from the listener.
Pre/Post Amp - Knob 2 determines where the effect appears in the effects chain. Turn
counter-clockwise for Pre (appears before the Distortion effect), or clockwise for Post
(appears after the Noise Gate effect).
Speed-Knob3 adjusts the rate (Speed) of the spinning speakers. Ranges from  to .
Intensity - Knob 4 controls the intensity of the effect. Ranges from  to .
Doppler-Knob5 controls the Pitch Shift effect that is the ratio between the horn and
the rotor positions. Ranges from  to .
Crossover - Knob 6 selects the crossover frequency between the horn and rotor.
Ranges from  (200 Hz) to  (1600 Hz).
VibroPan()
A vibrato is an effect that modulates the pitch of the incoming signal. This will take the whole
signal slightly in and out of tune at a steady pace. The DigiTech
®
VibroPan also incorporates an
automatic panner with the vibrato effect that creates a lush chorus-like sound.
Pre/Post Amp - Knob 2 determines where the effect appears in the effects chain. Turn
counter-clockwise for Pre (appears before the Distortion effect), or clockwise for Post
(appears after the Noise Gate effect).
Speed - Knob3 adjusts how fast the signal is being modulated.
Depth - Knob 4 adjusts the amount of pitch change.
Vibrato/Pan- Knob5 adjusts the amount of panning incorporated with the vibrato effect.
When set at , this effect is a standard vibrato. As the parameter is turned up, the phase
difference of the vibrato signal sent to the two channels is changed until a full stereo image
is obtained at .
Waveform - Knob 6 selects a waveform: , , or .
Unicord Uni-Vibe
TM
()
Based on the Unicord
®
Uni-Vibe
TM
pedal, Uni-Vibe adds a lush chorus or rotary speaker (vi-
brato) effect to your tone.
Pre/Post Amp - Knob 2 determines where the effect appears in the effects chain. Turn
counter-clockwise for Pre (appears before the Distortion effect), or clockwise for Post
(appears after the Noise Gate effect).
Speed-Knob3 adjusts the rate (Speed) of the chorus modulation or spinning speaker
(vibrato) effect. Ranges from  to .
Intensity - Knob 4 controls the intensity of the effect. Ranges from  to .
Chorus/Vibrato-Knob5 selects either the chorus or vibrato effect. Turn counter-
clockwise for Chorus, or clockwise for Vibrato.
Volume-Knob6 adjusts the volume of the effect.

DigiTech RP355 Specifications

General

Brand	DigiTech
Model	RP355
Category	Computer Hardware
Language	English