19
Flanger
A Flanger uses the same principle as a Chorus but uses a shorter delay time and adds regenera-
tion (or repeats) to the modulating delay. This results in an exaggerated up and down sweeping
motion to the effect. The RP355 includes the following Flanger Effect models: (the
DigiTech
®
Flanger), (the DigiTech Triggered Flanger), (based on an MXR
®
Flanger), and (based on an Electro-Harmonix
®
Electric Mistress).
Knobs 2-6 have the following functions for the various Flanger models:
Flanger
Model
Knob 2
(Pre/Post
Amp)
Knob3
(Speed)
Knob 4
(Depth)
Knob5
(Regenera-
tion)
Knob 6
(FX Level)
Pre/Post Amp Speed Depth Regen Level
Pre/Post Amp Speed Sensitivity LFO Start Level
Pre/Post Amp Speed Width Regen Manual
Pre/Post Amp Rate Range Color --
Phaser
A phaser splits the incoming signal, and then changes the phasing of the signal. This signal is then
taken in and out of phase and mixed back in with the original signal. As the phasing changes, dif-
ferent frequencies get canceled resulting in a warm sort of twisting sound. The RP355 includes
the following Phaser models: (the DigiTech Phaser), (the DigiTech Triggered
Phaser), (based on an MXR Phase 100), and (based on an Electro-Harmonix
Small Stone).
Knobs 2-6 have the following functions for the various Phaser models:
Phaser
Model
Knob 2
(Pre/Post
Amp)
Knob3
(Speed)
Knob 4
(Depth)
Knob5
(Regenera-
tion)
Knob 6
(FX Level)
Pre/Post Amp Speed Depth Regen Level
Pre/Post Amp Speed Sensitivity LFO Start Level
Pre/Post Amp Speed Intensity -- --
Pre/Post Amp Rate -- Color --
Vibrato ()
The DigiTech Vibrato effect modulates the pitch of the incoming signal at an even rate.
Pre/Post Amp - Knob 2 determines where the effect appears in the effects chain. Turn
counter-clockwise for Pre (appears before the Distortion effect), or clockwise for Post
(appears after the Noise Gate effect).
Speed-Knob3 adjusts the rate (Speed) at which the pitch modulates. Ranges from to
.
Depth - Knob 4 adjusts the intensity (Depth) of the modulating pitch. Ranges from to
.