38
blow into a breath control device. It is with CCÕs that you introduce
dynamics and emotion into your harmony performance.
Vocalist Workstation EX parameters you can modify by continuous con-
trol and their default MIDI mappings:
¥ Volume to MIDI Volume (CC 7)
¥ Detune to Expression Controller (CC 11)
¥ Vibrato Depth to Modulation Wheel (CC 1)
¥ Vibrato Rate to Effect Control 1 (CC 12)
¥ Harmony Hold to Effect Control 2 (CC 13)
The Harmony Hold works with Chordal and Scalic harmony programs
to freeze the current harmonies while you continue to sing notes that
would otherwise cause the harmonies to change. ItÕs useful when you
want to throw some vocal ÒriffsÓ in a part of song and donÕt want the har-
monies to follow.
To change the Continuous Controller mapping:
1. Press the Utilities button from any mode. This presents the
UTILITIES main menu.
2. Press the soft key corresponding to MIDI. This presents the MIDI
Utilities sub-menu.
3. Press the soft key corresponding to CC.
4. Use the softkeys to select one of the three editable fields in the MIDI
Controllers screen: the internal parameter you want to control, the
CC that controls it and the control polarity. The control polarity can
be used to reverse the response of the controller.
5. Press the Utilities button to exit to the previous mode.
MIDI Program Change mapping
Incoming MIDI Program Change messages can be remapped to any of
the Vocalist Workstation EXÕs internal programs. Remapping simply
means that when you send the product a MIDI program change number
1, you have the option of making that number call up some other pro-
gram instead. This allows the product to adapt to existing program
changes in MIDI sequences or MIDI performance controllers.
Any incoming Program Change command can be:
¥ Mapped to the same program number in the Vocalist Workstation
EX
¥ Mapped to any other program number
¥ Mapped to enable Bypass mode
¥ Ignored by the Vocalist Workstation EX (no change from previously
loaded program)
Note:
All CC’s except
Volume (CC7) reset to
their default values
when a MIDI program
change message is
received.
To Next Page
Loading...
Need help?
General
