Need help?Do you have a question about the DIGITEN DTC-102 and is the answer not in the manual?
Details the function of each indicator and control element on the thermostat's display and panel.
Guide on switching between Celsius (°C) and Fahrenheit (°F) temperature display units.
Instructions for adjusting the Set Value (SV) of the thermostat for desired temperature control.
Procedure for setting additional functions and parameters beyond basic SV adjustment.
Steps to reset the thermostat to its original factory default configuration.
Table detailing the setting ranges and default values for various thermostat functions.
Explains how the thermostat operates in cooling mode, including start and stop conditions.
Details the thermostat's behavior and control logic when operating in heating mode.
Covers high/low alarms, compressor delay, and unconventional setting handling.
Procedures for temperature calibration, unit selection (C/F), and LCD backlight control.
Explanation of error codes (Err, HL) and their resolution for sensor or range issues.
Understanding the green LED flashing during compressor delay protection.
Details the warranty period and contact information for DIGITEN products.
Critical safety precautions, including overload limits and water protection.
General| Temperature Control Resolution | 0.1°C |
|---|---|
| Power Consumption | ≤3W |
| Output Type | Relay |
| Relay Contact Current | 10A |
| Load Current | 10A |
| Mounting | Panel Mount |
| Temperature Measuring Range | -50°C to 110°C |
| Temperature Controlling Range | -50°C to 110°C |
| Accuracy | ±1°C |
| Sensor | NTC sensor |
To Next Page
