Need help?Do you have a question about the DIGITEN WTC200 and is the answer not in the manual?
Identifies the WTC100 and WTC200 receiver units and their key indicators.
Introduces the remote control unit for the thermostat system.
Steps to pair the remote controller with the receiver unit for communication.
How to switch between Celsius (°C) and Fahrenheit (°F) on the controller.
Explains how the thermostat operates in cooling mode based on temperature settings.
Details the high and low temperature alarm functions and their indications.
Explains the compressor delay function to prevent premature restarts.
Procedure to restore all settings to their original factory defaults.
Addresses common issues like incorrect temperature readings and operational problems.
Information on product warranty, overload, and water resistance warnings.
General| Type | Digital Thermostat |
|---|---|
| Temperature Control Resolution | 0.1 °C |
| Refresh rate | 1 second |
| Input Power | 100-240V AC, 50/60Hz |
| Measuring input | NTC 10KΩ sensor |
| Output | Relay output |
| Environmental requirements | 0°C to 50°C (32°F to 122°F), ≤85% RH (non-condensing) |
| Power consumption | < 2 W |
| Accuracy | ±1°C (±1.8°F) |
| Display | LCD |
| Control Type | On/Off |
| Power Supply | 100-240V AC, 50/60Hz |
| Temperature Measurement Accuracy | ±1 °C |
To Next Page
