cooling operation stops, the relay has no output, the LCD displays , the
green light on the receiver is off. When the CURRENT value rises to the RUN
value, the cooling operation starts, the LCD displays , the green light on
the receiver is on.
Heating mode
Set the temperature value RUN<STOP, the controller is in heating mode, and
the LCD displays the HEATING symbol
2.1 When the CURRENT temperature is less than or equal to the
RUN value, the heating operation
starts, the relay outputs, the LCD
displays , the green light on the receiver is on, when the CURRENT rises
to the STOP value, the heating operation stops, the LCD displays , the
green light on the receiver is off.
2.2 When the CURRENT temperature value is greater than the STOP value,
the heating operation stops, the LCD displays , the green light on the
receiver is off, when the CURRENT temperature drop to the RUN value, the
heating work starts, the LCD displays , the green light on the receiver is
on.
High and low temperature alarm
When the CURRENT temperature is greater than the HIGH value or less than
the LOW value, the remote controller will alarm and the symbol on the LCD will
flash. Press any key to stop the sound, and the symbol continues to flash until
the setting value is changed or CURRENT temperature value returns to the
alarm range.
If the transmitter
is not powered, the receiver will continue
previous setting value until 5
Delay function
Damage can occur if the compressor restarted too soon after shutdown.
This feature forces the compressor to wait for a few minutes before restarting.
During the waiting time, the display will flash , When the safe waiting
time has elapsed, the display stop flashing and the compressor turns on
To Next Page
